Stores the current directory for use by the popd command, and then changes to the specified directory.
For examples of how to use this command, see Examples.
Specifies the directory to make the current directory. This command supports relative paths.
Displays help at the command prompt.
- Every time you use the pushd command, a single directory
is stored for your use. However, you can store multiple directories
by using the pushd command multiple times.
The directories are stored sequentially in a virtual stack. If you use the pushd command once, the directory in which you use the command is placed at the bottom of the stack. If you use the command again, the second directory is placed on top of the first one. The process repeats every time you use the pushd command.
You can use the popd command to change the current directory to the directory most recently stored by the pushd command. If you use the popd command, the directory on the top of the stack is removed from the stack and the current directory is changed to that directory. If you use the popd command again, the next directory on the stack is removed.
- If command extensions are enabled, the pushd command
accepts either a network path or a local drive letter and path.
- If you specify a network path, the pushd command
temporarily assigns the highest unused drive letter (starting with
Z:) to the specified network resource. The command then changes the
current drive and directory to the specified directory on the newly
assigned drive. If you use the popd command with command
extensions enabled, the popd command removes the
drive-letter assignation created by pushd.
The following example shows how you can use the pushd command and the popd command in a batch program to change the current directory from the one in which the batch program was run and then change it back:
@echo off rem This batch file deletes all .txt files in a specified directory pushd %1 del *.txt popd cls echo All text files deleted in the %1 directory