Command:

x25 htc

Mode:

Router(config-if)#


Syntax:

x25 htc circuit-number


Syntax Description:
circuit-number 

VC number from 1 to 4095, or 0 if there is no two-way VC range.


Command Description:

To set the highest two-way virtual circuit (VC) number, use the x25 htc interface configuration command.

Usage Guidelines

When X.25 calls are placed across the interface between an X.25 DTE and the X.25 network, virtual circuits (VC) are established to carry the data associated with the calls. These VCs fall into the following categories: Permanent Virtual Circuits (PVCs), incoming-only, two-way, and outgoing-only. All VCs are numbered, and each of these categories occupies a consecutive range. All PVCs must be numerically lower than all incoming-only VCs, which in turn must be lower than all two-way VCs, which in turn must be lower than all outgoing-only VCs.


Example:

The following example sets a valid two-way VC range of 5 to 25:

Router(config)#interface serial 0/0
 Router(config-if)#x25 ltc 5
 Router(config-if)#x25 htc 25

Misconceptions:
None

Related commands:
x25 lic
x25 hic
x25 hoc
x25 loc
x25 ltc

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)