set origin (BGP)




set origin {igp | egp as-number | incomplete}
no set origin {igp | egp as-number | incomplete}


Syntax Description:

igp Remote Interior Gateway Protocol (IGP) system.
egp Local Exterior Gateway Protocol (EGP) system.
as-number Remote autonomous system number. This is an integer from 0 to 65535.
incomplete Unknown heritage.


Command Description:

To set the BGP origin code, use the set origin command in route-map configuration mode. To delete an entry, use the no form of this command.

The default is based on the route in the main IP routing table.

You must have a match clause (even if it points to a "permit everything" list) if you want to set tags.

Use the route-map (IP) global configuration command with the match and set route-map configuration commands to define the conditions for redistributing routes from one routing protocol into another, or for policy routing. Each route-map command has an associated list of match and set commands. The match commands specify the match criteria--the conditions under which redistribution or policy routing is allowed for the current route-map command. The set commands specify the set actions--the particular redistribution or policy routing actions to perform if the criteria enforced by the match commands are met. The no route-map command deletes the route map.

The set route-map configuration commands specify the redistribution set actions to be performed when all of the match criteria of a route map are met.


The following example sets the origin of routes that pass the route map to IGP:

Router(config)# route-map set_origin
Router(config-route-map)# match as-path 10
Router(config-route-map)# set origin igp



Related Commands:

match as-path
match community
match interface
match ip address
match ip next-hop
match ip route-source
match metric
match route-type
match tag
set community
set metric
set tag
set weight

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)