Command:

ipx routing


Mode:

Router(config)#

Syntax:

ipx routing node

no ipx routing


Syntax Description:

 

node

The node number is either user specified or the MAC address of the first Ethernet, Token or FDDI card.


Command Description:

To enable IPX routing, use the ipx routing global configuration command. To disable IPX routing, use the no form of this command. Node is a 48-bit value represented by a dotted triplet of four-digit hexadecimal numbers (xxxx.xxxx.xxxx). It must not be a multicast address. If you omit node, the Cisco IOS software uses the hardware MAC address currently assigned to it as its node address. This is the MAC address of the first Ethernet, Token Ring, or FDDI interface card. If no satisfactory interfaces are present in the router (such as only serial interfaces), you must specify node.


Example:
Router(config)#ipx routing

Misconceptions:
None

Related Commands:
ip routing
ipx router

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)