ip local policy route-map
ip local policy route-map map-tag
no ip local policy route-map map-tag
map-tag Name of the route map to use for local policy routing. The name must match a map-tag value specified by a route-map command.
To identify a route map to use for local policy routing, use the ip local policy route-map command in global configuration mode. To disable local policy routing, use the no form of this command.
Packets that are generated by the router are not normally policy routed. However, you can use this command to policy route such packets. You might enable local policy routing if you want packets originated at the router to take a route other than the obvious shortest path.
The ip local policy route-map command identifies a route map to use for local policy routing. Each route-map command has a list of match and set commands associated with it. The match commands specify the match criteria--the conditions under which packets should be policy routed. The set commands specify the set actions�the particular policy routing actions to perform if the criteria enforced by the match commands are met. The no ip local policy route-map command deletes the reference to the route map and disables local policy routing.
By default, packets that are generated by the router are not policy routed.
The following example sends packets with a destination IP address matching that allowed by extended access list 131 to the router at IP address 188.8.131.52:Router(config)#ip local policy route-map xyz Router(config)#route-map xyz Router(config-route-map)#match ip address 131 Router(config-route-map)#set ip next-hop 184.108.40.206
match ip address
set default interface
set ip default next-hop verify-availability
set ip next-hop
show ip local policy
� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education
|Converted from CHM to HTML with chm2web Pro 2.85 (unicode)|