Command:

show frame-relay map

 

Mode:

Router#


Syntax:

show frame-relay map


Syntax Description:

This command has no arguments or keywords.


Command Description:

To display the current map entries and information about the connections, use the show frame-relay map EXEC command.


Example:

The following is a sample of output from the show frame-relay map command:

Router# show frame-relay map


Serial 1 (administratively down): ip 131.108.177.177
dlci 177 (0xB1,0x2C10), static, broadcast, CISCO
TCP/IP Header Compression (inherited), passive (inherited)
 

The following table describes significant fields shown in the display:

Table: show frame-relay map Field Descriptions

Field Description

Serial 1 (administratively down)

Identifies a Frame Relay interface and its status (up or down).

ip 131.108.177.177

Destination IP address.

dlci 177 (0xB1,0x2C10)

DLCI that identifies the logical connection being used to reach this interface. This value is displayed in three ways: its decimal value (177), its hexadecimal value (0xB1), and its value as it would appear on the wire (0x2C10).

static

Indicates whether this is a static or dynamic entry.

CISCO

Indicates the encapsulation type for this map, either CISCO or IETF.

TCP/IP Header Compression (inherited), passive (inherited)

Indicates whether the TCP/IP header compression characteristics were inherited from the interface or were explicitly configured for the IP map.


Misconceptions:

None


Related commands:

show frame-relay pvc

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)