Command:  

show clns route


Mode:

Router#
Router>


Syntax:

  show clns route nsap

 

Syntax Description:      

nsap

CLNS network service access point (NSAP) address.

 

Command Description:

The show clns routecommand shows the Intermediate System-to-Intermediate System (IS-IS) Level 2 routing table and static and Intermediate System-to-Intermediate System Interior Gateway Routing Protocol (ISO-IGRP) learned prefix routes. This table stores IS-IS area addresses and prefix routes.

Example:

The following is sample output from the show clns routecommand when the nsapargument is not used:

Router# show clns route

ISO-IGRP Routing Table for Domain 49.0002, Area 0007

System Id Next-Hop SNPA Interface Metric State

milles milles *HDLC* Se1 8476 Up

0000.0000.0007 milles *HDLC* Se1 10476 Up

rips 0000.0000.0000 -- -- 0 Up

ISO-IGRP Routing Table for Domain 49.0002

Area Id Next-Hop SNPA Interface Metric State

0002 0000.0000.0000 -- -- 0 Up

Codes: C - connected, S - static, d - DecnetIV

I - ISO-IGRP, i - IS-IS, e - ES-IS

C 49.0002 [2/0], Local ISO-IGRP Domain

C 49.0001.0000.0000.0005.00 [1/0], Local IS-IS NET

C 49.0002.0007.0000.0000.0005.00 [1/0], Local ISO-IGRP NET

C 49.0001 [2/0], Local IS-IS Area

i 33.3333.3333 [110/10]

via bakel, Ethernet0

S 50.1234 [10/0], Discard Entry

I 55.5555.5555 [100/8476]

via milles, Serial1

S 77.7777.7777.7777 [10/0]

via Serial0

d 88.8888.8888.0007 [120/0], DecnetIV Entry

i 33.4567.8901 [110/10]

via bakel, Ethernet0


Misconceptions:

None


Related commands:

 

     None

 


© Cisco Systems, Inc. 2001, 2002
World Wide Education






Converted from CHM to HTML with chm2web Pro 2.85 (unicode)