set next-hop next-hop
no set next-hop next-hop
next-hop IP address of the next hop router.
To specify the address of the next hop, use the set next-hop command in route-map configuration mode. To delete an entry, use the no form of this command.
The default is the next hop address.
You must have a match clause (even if it points to a "permit everything" list) if you want to set tags.
Use the route-map (IP) global configuration command with the match and set route-map configuration commands to define the conditions for redistributing routes from one routing protocol into another, or for policy routing. Each route-map command has an associated list of match and set commands. The match commands specify the match criteria--the conditions under which redistribution or policy routing is allowed for the current route-map command. The set commands specify the set actions--the particular redistribution or policy routing actions to perform if the criteria enforced by the match commands are met. The no route-map command deletes the route map.
The set route-map configuration commands specify the redistribution set actions to be performed when all of the match criteria of a route map are met.
In the following example, routes that pass the access list have the next hop set to 220.127.116.11:Router(config)# route-map map_hop Router(config-route-map)# match address 5 Router(config-route-map)# set next-hop 18.104.22.168
match ip address
match ip next-hop
match ip route-source
� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education
|Converted from CHM to HTML with chm2web Pro 2.85 (unicode)|