Command:

permit (standard)

Mode:

Router(config-std-nacl)#

Syntax:

permit {source [source-wildcard] | any} [log]

Syntax Description:

source 

Number of the network or host from which the packet is being sent. There are two alternative ways to specify the source:

Use a 32-bit quantity in four-part, dotted-decimal format.

source-wildcard

(Optional) Wildcard bits to be applied to the source. There are two alternative ways to specify the source wildcard:

Use a 32-bit quantity in four-part, dotted-decimal format. Place ones in the bit positions to be ignored.

log

(Optional) Causes an informational logging message about the packet that matches the entry to be sent to the console. (The level of messages logged to the console is controlled by the logging console command.)

any

applies the list to all sources


Command Description:

In access-list configuration mode, specify one or more conditions allowed. Packets matching this condition will be allowed to pass through the interface.


Example:

This example adds a entry to an IP standard named access control list that permits all IP traffic from network 36.0.0.0:  

Router(config-std-nacl)#permit 36.0.0.0 0.255.255.255

 

Misconceptions:

 

None


Related Commands:

 

ip access-list standard

 

deny (standard)

 


� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)