no output-delay [delay]
delay Delay (in milliseconds) between packets in a multiple-packet RIP update. The range is from 8 to 50 milliseconds. The default is no delay.
To change the interpacket delay for Routing Information Protocol (RIP) updates sent, use the output-delay command in router configuration mode. To remove the delay, use the no form of this command.
The default is 0 milliseconds.
Consider using this command if you have a high-end router sending at high speed to a low-speed router that might not be able to receive at the high speed. Configuring this command will help prevent the routing table from losing information.
The following example sets the interpacket delay to 10 milliseconds:Router(config-router)# output-delay 10
� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education
|Converted from CHM to HTML with chm2web Pro 2.85 (unicode)|