Command:

neighbor remote-as


Mode:

Router(config-router)#


Syntax:

neighbor {ip-address | peer-group-name} remote-as as-number

no neighbor {ip-address | peer-group-name} remote-as as-number

 

Syntax Description:

ip-address

Neighbor's IP address

peer-group-name

Name of a BGP peer group

as-number

Autonomous system to which the neighbor belongs

 

Command Description:

To add an entry to the BGP or multiprotocol BGP neighbor table, use the neighbor remote-as router configuration command. To remove an entry from the table, use the no form of this command. 

Usage Guidelines: 

Specifying a neighbor with an autonomous system number that matches the autonomous system number specified in the router bgp global configuration command identifies the neighbor as internal to the local autonomous system. Otherwise, the neighbor is considered external. If you specify a BGP peer group by using the peer-group-name argument, all the members of the peer group will inherit the characteristic configured with this command.

 

Example:

The following example specifies that a router at the address 131.108.1.2 is a neighbor in autonomous system number 109:

Router(config)#router bgp 110

Router(config-router)#network 131.108.0.0

Router(config-router)#neighbor 131.108.1.2 remote-as 109

Misconceptions:

 

None


Related Commands:

 

router bgp

 

neighbor peer-group

 


� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)