Command:

ipx type-20-propagation


Mode:

Router(config-if)#

Syntax:

ipx type-20-propagation

no ipx type-20-propagation


Syntax Description:

This command has no arguments or keywords.


Command Description:

To forward IPX type 20 propagation packet broadcasts to other network segments, use the ipx type-20-propagation interface configuration command. To disable both the reception and forwarding of type 20 broadcasts on an interface, use the no form of this command.

Routers normally block all broadcast requests. To allow input and output of type 20 propagation packets on an interface, use the ipx type-20-propagation command. Note that type 20 packets are subject to loop detection and control as specified in the IPX router specification.


Example:

The following example enables both the reception and forwarding of type 20 broadcasts on FastEthernet interface 0/0:

Router(config)#interface fastethernet 0/0
Router(config-if)#ipx type-20-propagation
 

The following example enables the reception and forwarding of type 20 broadcasts between networks 123 and 456, but does not enable reception and forwarding of these broadcasts to and from network 789:

Router(config)#interface fastethernet 0/0
Router(config-if)#ipx network 123
Router(config-if)#ipx type-20-propagation

Router(config)#interface fastethernet 0/1
Router(config-if)#ipx network 456
Router(config-if)#ipx type-20-propagation

Router(config)#interface fastethernet 0/2
Router(config-if)#ipx network 789

Misconceptions:
None

Related Commands:
None

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)