Command:

ipx bandwidth-percent eigrp


Mode:

Router(config-if)#


Syntax:

ipx bandwidth-percent eigrp as-number percent
no ipx bandwidth-percent eigrp as-number

 

Syntax Description:

as-number Autonomous system number.
percent Percentage of bandwidth that Enhanced IGRP may use.

 

Command Description:

To configure the percentage of bandwidth that may be used by Enhanced Interior Gateway Routing Protocol (EIGRP) on an interface, use the ipx bandwidth-percent eigrp command in interface configuration mode. To restore the default value, use the no form of this command.

Enhanced IGRP will use up to 50 percent of the bandwidth of a link, as defined by the bandwidth interface configuration command. This command may be used if some other fraction of the bandwidth is desired. Note that values greater than 100 percent may be configured; this may be useful if the bandwidth is set artificially low for other reasons.


Example:

The following example allows Enhanced IGRP to use up to 75 percent (42 kbps) of a 56-kbps serial link in autonomous system 209:

Router(config-if)# interface serial 0
Router(config-if)# bandwidth 56
Router(config-if)# ipx bandwidth-percent eigrp 209 75


Misconceptions:

None


Related Commands:

bandwidth
ipx router

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)