Command:

ip split-horizon eigrp


Mode:

Router(config-if)#


Syntax:

ip split-horizon eigrp as-number

no ip split-horizon eigrp as-number

 

Syntax Description:

as-number

Autonomous system number.

Defaults

The behavior of this command is enabled by default.

 

Command Description:

 

To enable Enhanced IGRP (EIGRP) split horizon, use the ip split-horizon eigrp command in interface configuration mode. To disable split horizon, use the no form

 

For networks that include links over X.25 packet-switched networks (PSNs), you can use the neighbor router configuration command to defeat the split horizon feature. As an alternative, you can explicitly specify the no ip split-horizon eigrp command in your configuration. However, if you do so, you must similarly disable split horizon for all routers and access servers in any relevant multicast groups on that network.

Note: In general, we recommend that you not change the default state of split horizon unless you are certain that your application requires the change in order to properly advertise routes. Remember that if split horizon is disabled on a serial interface and that interface is attached to a packet-switched network, you must disable split horizon for all routers and access servers in any relevant multicast groups on that network.


Example:

The following example disables split horizon on a serial link connected to an X.25 network:

interface serial 0

 encapsulation x25

 no ip split-horizon eigrp 101


Misconceptions:

           None.


Related Commands:


neighbor (IGRP) 

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)