Command:

ip rip receive version


Mode:

Router(config-if)#


Syntax:

ip rip receive version [1] [2]
no ip rip receive version

 

Syntax Description:

1 (Optional) Accepts only RIP Version 1 packets on the interface.
2 (Optional) Accepts only RIP Version 2 packets on the interface.

 

Command Description:

To specify a Routing Information Protocol (RIP) version to receive on an interface basis, use the ip rip receive version command in interface configuration mode. To follow the global version rules, use the no form of this command.

This command is disabled by default.

Use this command to override the default behavior of RIP as specified by the version command. This command applies only to the interface being configured. You can configure the interface to accept both RIP versions.


Example:

The following example configures the interface to receive both RIP Version 1 and Version 2 packets:

Router(config-if)#ip rip receive version 1 2

The following example configures the interface to receive only RIP Version 1 packets:

Router(config-if)#ip rip receive version 1


Misconceptions:

None


Related Commands:

ip rip authentication key-chain
key chain
ip rip send version
version

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)