Command:

frame-relay traffic-rate

Mode:

Router(config-map-class)#

Syntax:

frame-relay traffic-rate average [peak]

no frame-relay traffic-rate average [peak]


Syntax Description:
average 

Average rate, in bits per second; equivalent to specifying the contracted CIR.

peak 

(Optional) Peak rate, in bits per second; equivalent to CIR + Be/Tc = CIR (1 + Be/Bc) = CIR + EIR.


Command Description:

To configure all the traffic shaping characteristics of a virtual circuit in a single command, use the frame-relay traffic-rate map-class configuration command. To remove the specified traffic shaping from the map class, use the no form of this command.

Usage Guidelines

For SVCs, the configured peak and average rates are converted to the equivalent CIR, excess burst size (Be), and committed burst size (Bc) values for use by SVC signaling.

This command lets you configure all the traffic shaping characteristics of a virtual circuit in a single command. Using it is simpler than the alternative of entering the three subcommands frame-relay cir out, frame-relay be out and frame-relay bc out, but offers slightly less flexibility.

Example:

The following example associates a map class with specified DLCI and then sets a traffic rate for the map-class (and thus for the DLCI):

Router(config)#interface serial 0/0
Router(config-if)#frame-relay interface-dlci 100 class fast_vc

Router(config)#map-class frame-relay fast_vc
Router(config-map-class)#frame-relay traffic-rate 56000 128000

Misconceptions:
None

Related Commands:
frame-relay cir

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)