Command:

dialer-group


Mode:

Router(config-if)#


Syntax:

dialer-group group-number

no dialer-group

 

Syntax Description:

group-number

This specifies the number of the dialer access group to which the specific interface belongs. This access group is defined with the dialer-list command. Acceptable values are nonzero, positive integers between 1 and 10.

Command Description:

To control access by configuring an interface to belong to a specific dialing group, use the dialer-group command in interface configuration mode. Use the no form of this command to remove an interface from the specified dialer access group.


Example:

The following example specifies dialer access group number 1. The destination address of the packet is evaluated against the access list specified in the associated dialer-list command. If it passes, either a call is initiated (if no connection has already been established) or the idle timer is reset (if a call is currently connected).

  Router(config)#interface async 1
  Router(config-if)#dialer-group 1
  Router(config-if)#exit
  Router(config)#access-list 101 deny igrp 0.0.0.0 255.255.255.255 255.255.255.255 0.0.0.0
  Router(config)#access-list 101 permit ip 0.0.0.0 255.255.255.255 0.0.0.0 255.255.255.255 
  Router(config)#dialer-list 1 protocol ip list 101

 

Misconceptions:

 

None


Related Commands:

 

dialer-list protocol

 


� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)