Command:

dialer pool


Mode:

Router(config-if)#

Syntax:

 

dialer pool number

 

no dialer pool number

 

Syntax Description:

 

number 

Dialing pool number, in the range 1 through 255.

 

Command Description:

To specify, for a dialer interface, which dialing pool to use to connect to a specific destination subnetwork, use the dialer pool interface configuration command.

This command applies to dialer interfaces only.


Example:

The following example shows a dialer interface configuration that is linked to the physical interface configuration shown for BRI 1 in the dialer pool-member command section. Dialer interface 1 uses dialer pool 3, of which BRI 1 is a member.

This is a dialer profile for reaching remote subnetwork 1.1.1.1.

Router(config)#interface Dialer1
Router(config-if)#ip address 1.1.1.1 255.255.255.0
Router(config-if)#encapsulation ppp 
Router(config-if)#dialer remote-name Smalluser 
Router(config-if)#dialer string 4540
Router(config-if)#dialer pool 3
Router(config-if)#dialer-group 1


The following example might accompany the previous dialer profile configuration example. Physical interface BRI 1 has a reserved channel in dialer pool 3. That channel is inactive until BRI 1 uses it to place calls.
Router(config)#interface BRI1
Router(config-if)#encapsulation ppp 
Router(config-if)#dialer pool-member 1 priority 50
Router(config-if)#dialer pool-member 2 priority 50
Router(config-if)#dialer pool-member 3 min-link 1
Router(config-if)#ppp authentication chap

Misconceptions:
None

Related Commands:
dialer pool-member

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)