Command:

dialer pool-member


Mode:

Router(config-if)#

Syntax:

dialer pool-member number [priority priority] [min-link minimum] [max-link maximum]

no dialer pool-member

 

Syntax Description:

number 

Dialing pool number, in the range 1 through 255.

priority  priority 

(Optional) Priority of this interface within the dialing pool, in the range 0 (lowest) to 255 (highest). Interfaces with the highest priority are selected first for dialing out. Default is 0.

min-link  minimum 

(Optional) Minimum number of B channels on this interface that are reserved for this dialing pool, in the range 0 to 255. Default is 0. A reserved channel is inactive until the specified interface uses it to place calls. Applies to ISDN interfaces only.

max-link  maximum 

(Optional) Maximum number of B channels on this interface that can be used by this dialing pool, in the range 0 to 255. Default is 255. Applies to ISDN interfaces only.

 

Command Description:

To configure a physical interface to be a member of a Dialer Profiles dialing pool, use the dialer pool-member interface configuration command.

Example:

The following example shows the configuration of one ISDN BRI interface to be a member of dialer pool 2 with priority 100:

Router(config)#interface bri 2
Router(config-if)#encapsulation ppp
Router(config-if)#dialer pool-member 2 priority 100
Router(config-if)#ppp authentication chap
In the following example, BRI physical interface configuration BRI 1 has a reserved channel in dialer pool 3. That channel is inactive until BRI 1 uses it to place calls.
Router(config)#interface bri 1
Router(config-if)#encapsulation ppp
Router(config-if)#dialer pool-member 1 priority 50
Router(config-if)#dialer pool-member 2 priority 50
Router(config-if)#dialer pool-member 3 min-link 1
Router(config-if)#ppp authentication chap
Misconceptions:
None

Related Commands:
dialer pool

� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)