Command:

bandwidth


Mode:

Router(config-if)#


Syntax:

bandwidth kilobits

no bandwidth  

 

Syntax Description:

kilobits

Intended bandwidth in kilobits per second


Command Description:

To set a bandwidth value for an interface, use the bandwidth command in interface configuration mode. The bandwidth command sets an informational parameter to communicate only the current bandwidth to the higher-level protocols.


Example:

The following command sequence will set the bandwidth of serial 0/0 to 1.54 megabits per second. 

Router(config)#interface serial 0/0
Router(config-if)#bandwidth 1540


Misconceptions:

The bandwidth is occasionally misinterpreted as a command to modify the bandwidth rate of an interface. You cannot adjust the actual bandwidth of an interface with this command.


Related Commands:

 

None

 


� Cisco Systems, Inc. 2001, 2002, 2003
World Wide Education

Converted from CHM to HTML with chm2web Pro 2.85 (unicode)